MileCheck

Pins show recorded DOT mileposts. Positions are approximate.

Loading mile markers…

Want YOUR mile marker, in real time?

The app shows your exact position down to a tenth of a mile as you drive — offline, in all 50 states, on CarPlay and Android Auto.

App Store Google Play

How mile markers are numbered

The small green signs along a highway are called reference location signs in the federal sign manual, the MUTCD. The 2023 edition requires them on all freeways, in part so crashes and emergencies can be located. They also help drivers judge progress and help with highway maintenance.

Zero is at the south or west state line, or where the route begins inside the state. On a divided highway the distance is measured on the northbound or eastbound side. The sign for the other direction goes directly across from it, so both sides show the same number at the same spot. Signs go on the right side of the road, or in the median where the right side won't work, up to 30 feet from the pavement.

Interstate mile numbers generally start over at each state line. Northbound on I-75, Florida's markers pass 470 near the Georgia line, and Georgia's begin again near zero. Some states also run county-based systems, covered in the list below.

Tenths and enhanced markers

States may add intermediate markers every tenth, two tenths or half mile. When they do, the whole-mile marker shows a decimal and a zero, such as 42.0. Some states use enhanced markers instead. Those are vertical green signs with the direction on top, then the route shield, then the mile. The intermediate version adds the tenth on a bottom line. Both are optional, so you will see them in some states and not others.

Exit numbers use the same count

The MUTCD requires exit numbers to match the posted mile markers and says consecutive numbering shall not be used. Its guidance is that a crossroad meeting the highway between mile 15 and mile 16 becomes exit 15. When interchanges sit too close to number by the mile, letters split them. The manual's example is 256A. Once 256A exists, there can't also be a plain exit 256 in the same direction.

The manual says this numbering helps drivers report their location after a crash or breakdown and helps responders reach them. It also means a new interchange doesn't force a renumbering. On a beltway that circles a city, exits are numbered clockwise, starting near the south end of the loop.

Some states switched around 2000. Georgia renumbered its interstate exits in 1999 and 2000, and exit 18 on I-75 at Tifton became exit 62. Florida moved I-4 and most of its other interstates to mile-based exits in 2002. Directions written before the change use the old numbers.

Where the numbers work differently

Why a pin may not match the sign

The pins on this map come from DOT milepost records, and positions are approximate. The MUTCD lets a sign move as much as 50 feet from its measured spot when it can't go in the right place. If it can't be placed within 50 feet, the MUTCD recommends leaving it out.

Roads also change. A realigned curve or a rebuilt interchange can move a sign while the record stays put. If the map and the roadside marker differ, report the number on the sign along with the highway, direction and state.

Using markers on a trip

On one route inside one state, subtracting markers gives distance. From mile 120 to mile 175 is 55 miles. Across a state line the count resets, so add what is left in the first state to the marker you reach in the next. The math stops working where the route shares pavement with another highway or follows a county-based system.

To find your own number, use What mile marker am I at? For the two numbering systems side by side, read mile markers vs exit numbers. For how interstates get their route numbers, see how interstates are numbered.